Household Wiper: Due to daily use in water, the handle often breaks near the bottom joint or gets weakened and separates due to rust.

Easy way to fix a broken wiper

How To Fix a Broken Floor Wiper Handle: A floor or bathroom wiper is a daily item. Due to daily use in water, the handle often breaks near the bottom joint or becomes weak and detaches due to rust. In such a situation, it's tempting to throw away the entire wiper, but sometimes it's just the handle or its joint that's damaged.

If your home's wiper handle breaks frequently, you can try a simple fix. Items like a plastic bottle, PVC pipe, or wooden stick can be used. Reattaching the broken part can make the wiper usable for a while.

First, see where it's broken.

Before repairing a wiper, it's important to determine the exact location of the problem. Sometimes, the handle breaks due to corrosion near the base socket. In some cases, the plastic joint itself cracks, separating the handle from the rubber part of the wiper. If any part of the broken handle is stuck in the socket, remove it first. Only after removing the rusted or broken part should you attempt to replace it. If there's any water or dirt around the joint, clean it and dry it thoroughly.

Strengthen joints with plastic bottles.

An empty plastic cold drink bottle can be used for this. Cut a piece of the bottle's plastic to fit snugly around the broken wiper joint. Now, place this plastic around the broken joint and the handle, covering the gap between the two parts. It's important to wrap the plastic tightly so that the handle doesn't move.

Gentle heat can be used to set the plastic at the joint. The heat may cause the plastic to shrink and form a tight bond around the joint. However, avoid using flames or excessive heat during this process. It's best to use heat carefully and avoid burning the plastic.

If the handle is completely broken, follow these steps:

If the old metal handle has completely deteriorated due to rust, instead of reassembling it, a new, stronger handle can be used. A small wooden handle, PVC pipe, or bamboo handle can be used for this. Fit it into the socket under the wiper according to the correct size. Tighten the joint with electrical tape if needed. Instant adhesive, or super glue, can also be used, but use a small amount and allow the joint to dry thoroughly before use. If the handle is loose in the socket, it's best to secure it securely with tape rather than just glue. This can reduce the problem of the handle sagging.

Be sure to tape over the joint.

The wiper handle is under constant pressure when used. Therefore, simply reattaching the broken part isn't enough. Apply several layers of waterproof duct tape or electrical tape over the repaired joint. Wrap the tape tightly around the joint, but don't tighten it so tightly that the plastic part is compressed and broken. After applying the tape, leave the wiper for a while and then gently check to see if the handle is moving.

How to prevent wipers from breaking again

The biggest problem with wipers is that they're often left in water after use. Especially in bathrooms, if the wiper is constantly left in a damp area, the metal parts are more likely to rust. Therefore, after use, keep the wiper upright or in a dry place to prevent water from accumulating on the handle and joints. If the wiper handle is made of metal, check the joints periodically. It's best to clean rust as soon as it appears, as early attention can prevent the part from weakening quickly.